Skip to content
DandenongConcreters

Driveways / Crossovers / Paths / Slabs / Patios

Shed and garage slabs in Dandenong

Slabs for garden sheds, garages, carports and workshops across Greater Dandenong, with the thickness and mesh specified by what will sit on them. Outbuildings only; we do not pour house or unit slabs.

Site measure Free, at your place
Quote Fixed, in writing
Steel In every slab
Area Greater Dandenong only

$110 to $150 per m², supplied and laid. Prices may vary with site conditions and variations.

A shed is only as good as the slab under it. A slab that is thin, unreinforced or poured on uncompacted fill will crack under the first vehicle, and by then the shed is bolted to it. The slab is the one part of the project that cannot be fixed later, which is why it is specified before it is priced.

Specified by what sits on it

A garden shed and a workshop with a hoist do not need the same slab, and quoting them the same is how slabs fail. Garden sheds with normal use are poured at 100mm with SL72 mesh. Garages, carports and workshops where vehicles, racking or machinery will sit are poured at 125mm with SL82 mesh, and edges are thickened where the shed manufacturer requires it. Rebates and hold-down points are formed in to the supplier’s drawings so the frame sits flat and the doors line up. The full build-up, including base preparation for Greater Dandenong’s clay, is on the specification page.

These slabs are for outbuildings. We do not pour dwelling or structural building slabs; for those, talk to your builder’s concreter.

The Dandenong shed slab

The dual occupancy and townhouse builds going up across Dandenong, Noble Park and Keysborough usually finish with a shed or double garage at the rear, and access is often a narrow side run between fences. Access is checked at the site measure, and where a truck cannot reach the pour, the concrete is barrowed or pumped and the quote says so up front rather than as a variation on the day.

What it costs

Shed and garage slabs run $110 to $150 per square metre supplied and laid, with the range driven by thickness, mesh and access. The cost guide has worked examples by shed size, and the calculator gives a range for your dimensions. Booked alongside a driveway or paths, the combined rate comes down because the crew mobilises once. Old slab in the way? Removal and replacement covers getting it out.

Concrete shed slab poured and cured, ready for the frame
Shed slab, screeded flat and ready for the frame

Where we pour shed and garage slabs

Dandenong, Dandenong North, Dandenong South, Keysborough, Noble Park, Springvale and nowhere else: one council, known inside out.

Your job, start to finish

What happens when you call

  1. 01

    Site measure

    Free, at your place. The job is measured, falls and access are checked, and finishes are picked from sample boards against the house in daylight.

  2. 02

    One written quote

    One fixed number in writing, itemised against the published specification. If a council crossover permit may be required, you know before anything is booked.

  3. 03

    The build

    The old surface out where there is one, base material brought in and compacted where the ground needs it, steel mesh laid, then the pour. Most residential jobs are one to two days on site.

  4. 04

    The finish

    Control joints cut to direct any movement, exposed aggregate washed and sealed after cure, and vehicles on it seven days after the pour.

Common questions

Shed and garage slabs questions

How much does a shed slab cost in Dandenong?

Shed and garage slabs run $110 to $150 per square metre supplied and laid, so a 6 m by 6 m garage slab typically lands between $4,000 and $5,500. Prices may vary with site conditions and variations; the written quote after a site measure is fixed.

How thick should a shed slab be?

A garden shed with normal use sits on a 100mm slab with SL72 mesh. A garage or workshop where vehicles or machinery will sit is specified at 125mm with SL82 mesh, with thickened edges where the shed manufacturer's drawings call for them. Tell us what is going in the shed and the slab is specified to match.

Do I need a permit for a shed slab?

The slab itself usually does not need one, but the shed that sits on it may. Larger sheds and garages can require a building permit depending on size and siting. Check with the City of Greater Dandenong or your shed supplier before the pour is booked.

Can you pour a slab where an old one is?

Yes. The old slab comes out first, the base is corrected, and the new slab is poured to the shed's drawings. Removal and disposal adds $35 per m2 on top of the slab rate.

One fixed written quote after a free site measure.

Call (03) 4059 3737 Get a quote